4 Solved calls, known defects, and

Limitations

A large number of calls were solved in service pack 3. On the Documentation

CD-ROM for this service pack you can find a Microsoft Word file that contains a

description of all solved calls. This file is named Solved_calls3.doc.

Service pack 3 is an incremental service pack. It also contains the solved calls of

service pack 1 and service pack 2. On the Documentation CD-ROM you can find

a Microsoft Word files that contains a description of all solved calls in service

pack 1. (Solved_calls.doc) and service pack 2 (Solved_calls2.doc).

Tinoway integration

The Tinoway integration of BaanService Remote (version 2.00.000.4

SP1through SP4) does not work with BaanERP5.0b SP2. Tinoway has developed

a new version BaanService Remote 2.1.3 that solved the defect. This solution is

validated for service pack 3 and service pack 2 for BaanERP5.0b.

Defect and solution outbound advice

The Service Pack 3 for BaanERP5.0b contains a defect that is discussed below.

Description of the defect

Assume the following:

n You have a production order.

n In the Bill of Material for the end-item, a material exists with backflushing

switched on.

You issue this material (for example, 50 pieces) for your production order in the

Material to Issue for Production Order (ticst0101m000) session. The Direct

Process Outbound check box is selected. Your warehouse does not hold

sufficient inventory of this material (for example, 30 pieces).

In such a case, the outbound order line in the Outbound Order Lines

(whinh2520m000) session must be split into two lines:

n 30 pieces, status shipped

n 20 pieces, status open

4 Solved calls, known defects, and

limitations

Solved calls, known defects, and limitations

Release Notes Service Pack 3

4-2

However, BaanERP creates three lines:

n 30 pieces, status shipped

n 20 pieces, status open

n 20 pieces, status open.

The creation of the last line is not correct; it should not have been created.

This defect can cause the following problem. If a customer generates and

releases the outbound advice and ships the goods in a batch process (while new

material is arrived in the warehouse), both lines will get the status shipped. In the

Material to Issue for Production Order (ticst0101m000) session, the To issue by

warehousing field will have the value –20, whereas no inbound line is available

with a value of + 20. Because this field should have the value 0, you cannot

close the production order.

Solution of the defect

This problem will be solved in Service Pack 4 for BaanERP5.0b. The Scopus

defect number for this problem is 7784; the solution number that belongs to this

defect is 18835.

An FTP-path is availabe:

If your Current VRC is:

B50_b:

ftp://www.support.baan.com/updates/B50b/18835std.dmp

To keep the dump compatible, more solutions than necessary to solve this

particular defect are available in the dump.

See the Scopus system for additional information.

Solution Defect

18722 75581

18815 75616

18754 76198

18753 76194