Data Upgrade after installation of solution 252405
Step 1. Display the run information
Complete these steps:
- Start the Data Upgrade Runs (ttspt2500m000) session.
- Go to the Run Information tab.
- Select the relevant package combination
Step 2. Create and initialize a new run
Perform this step only if the data upgrade run does not exist yet.
To create and initialize a new run:
- In the Data Upgrade Runs (ttspt2500m000) session, click New. The Initialize Data Upgrade Run (ttspt2200m000) session starts.
- Fill out the fields in the session. Among other things, specify this information:
-
- Mark the ‘Special Run‘ checkbox
-
- Fill the ‘Upgrade Task Source’ field with with the option ‘PMC Solution’
- Fill the ‘Base VRC’ field with ‘B61 a7’
- Fill the ‘PMC Solution’ field with ‘252405-09”
- Select the companies you want to upgrade
- Fill the ‘Source Feature Pack’ field with the value 6
Caution!
Ensure the correct source feature pack number is filled in. The data upgrades to be performed will be based on the specified source feature pack number:
- If the number is too low, too much data will be converted. Possibly data will be overwritten with wrong values.
- If the number is too high, not all data will be converted. Possibly data will not be consistent.
Note
- The initialization process assigns the specified feature pack number to all upgrade tasks in the run.
- After an incorrect initialization, you can correct the Source Feature Pack for the upgrade tasks/ upgrade programs in the run. To perform this correction, use the Global Change Source Feature Pack (ttspt2220m000) session.
Note: if you select the Start Data Upgrade Engine After Initialization check box, the run starts automatically after the initialization is finished. You cannot check the source feature pack or fine tune the run before it is started.
- Click Initialize.
- When the initialization is finished, a “Process completed” message is displayed. To remove the message box, click OK.
- Close the Initialize Data Upgrade Run (ttspt2200m000) session. The new run is displayed in the Data Upgrade Runs (ttspt2500m000) session.
- Start the upgrade by using the ‘Data Upgrade Engine…’ option in the specific menu of the Data Upgrade Runs (ttspt2500m000) session.